Set Up Job Costing
Enter machine and labor rates, cycle time, quantity, setup time, and an expected scrap percentage.
CNC Cost Calculator
Estimate CNC job cost from machine rate, labor rate, cycle time, setup, quantity, and scrap.
Metrik MFG / Job CostingREADY
CNC Cost Calculator
INPUTVALUEOUTPUT
Primary input01
Process setting02
Calculated output03
CALCULATION STATUSREADY TO CALCULATEEnter values below to generate results
STANDARD MODE
READY TO CALCULATE
CNC Cost Calculator
Advanced Engineering
PRACTICAL CONTEXT
Using the result in real shop work
This job-cost model separates machine and labor hourly cost from production and setup time. A scrap percentage can then be applied to the finished quantity.
Where This Result Helps
Use it for quote checks, internal cost analysis, and comparing the impact of cycle-time or setup changes.
What Can Distort the Result
Leaving out setup, using a machine rate that excludes overhead, or treating scrap as zero when the process has a measurable loss rate.
ENGINEERING METHOD
How the job costing calculation works.
FORMULAProduction cost = total productive hours × (machine rate + labor rate). Total job cost is adjusted for expected scrap.
RELATED CALCULATIONS
Related Engineering Calculations
Continue with connected machining, production, geometry, and shop calculations.
MANUFACTURING KNOWLEDGE
Related Guides & Articles
Practical information connected to machining, production, materials, tooling, and shop work.
GUIDE / ARTICLE
Why Unit Consistency Matters in Shop Calculations
Mixing inches, millimeters, SFM, RPM, and other unit families is one of the fastest ways to get a believable but wrong result.
GUIDE / ARTICLEBolt Circle Coordinates for CNC Drilling
Generate and verify bolt-circle X and Y coordinates before using a drilling pattern in a CNC program.
GUIDE / ARTICLESurface Finish and Feed Per Tooth
See how theoretical milling roughness changes as feed per tooth and tool diameter change.
GUIDE / ARTICLETap Drill Size: A Practical Starting Calculation
Use the common metric and inch starting relationships for tap-drill selection, then verify against the actual thread standard.
GUIDE / ARTICLEWhat Goes Into a CNC Machine Hourly Rate
Understand the difference between a simple machine rate and a rate that reflects real operating cost.
GUIDE / ARTICLECNC Machining Time: Cycle Time, Setup, and Job Planning
Turn cycle time into a realistic job duration by including setup time and a measured downtime allowance.
GUIDE / ARTICLEHow to Use Tool Life Data Without Guessing
A practical introduction to the Taylor tool-life equation and why its constants must come from real cutting data.
GUIDE / ARTICLEHow to Estimate Material Removal Rate
Learn the simple MRR relationship between feed rate, width of cut, and depth of cut.
GUIDE / ARTICLEFeed Rate vs Chip Load: The CNC Milling Relationship
See how spindle speed, flute count, and chip load combine to produce a milling feed rate.
GUIDE / ARTICLEHow to Calculate CNC Spindle Speed From SFM
A practical explanation of the spindle-speed formula and the inputs that matter before setting CNC RPM.