Set Up Feeds & Speeds
Enter programmed feed rate, spindle RPM, and the number of flutes.
Chip Load Calculator
Calculate milling chip load from feed rate, spindle speed, and flute count.
Metrik MFG / Feeds & SpeedsREADY
Chip Load Calculator
INPUTVALUEOUTPUT
Primary input01
Process setting02
Calculated output03
CALCULATION STATUSREADY TO CALCULATEEnter values below to generate results
STANDARD MODE
READY TO CALCULATE
Chip Load Calculator
Advanced Engineering
PRACTICAL CONTEXT
Using the result in real shop work
Chip load shows the feed per tooth. It is a key input for choosing a practical feed rate and balancing cutting performance with tool life.
Where This Result Helps
Use it to reverse-check a feed setting or compare chip load between tools and operations.
What Can Distort the Result
Confusing feed per tooth with feed per revolution or entering the wrong effective flute count for a toolpath.
ENGINEERING METHOD
How the feeds & speeds calculation works.
FORMULAChip load = feed rate ÷ (RPM × number of flutes).
RELATED CALCULATIONS
Related Engineering Calculations
Continue with connected machining, production, geometry, and shop calculations.
MANUFACTURING KNOWLEDGE
Related Guides & Articles
Practical information connected to machining, production, materials, tooling, and shop work.
GUIDE / ARTICLE
Why Unit Consistency Matters in Shop Calculations
Mixing inches, millimeters, SFM, RPM, and other unit families is one of the fastest ways to get a believable but wrong result.
GUIDE / ARTICLEBolt Circle Coordinates for CNC Drilling
Generate and verify bolt-circle X and Y coordinates before using a drilling pattern in a CNC program.
GUIDE / ARTICLESurface Finish and Feed Per Tooth
See how theoretical milling roughness changes as feed per tooth and tool diameter change.
GUIDE / ARTICLETap Drill Size: A Practical Starting Calculation
Use the common metric and inch starting relationships for tap-drill selection, then verify against the actual thread standard.
GUIDE / ARTICLEWhat Goes Into a CNC Machine Hourly Rate
Understand the difference between a simple machine rate and a rate that reflects real operating cost.
GUIDE / ARTICLECNC Machining Time: Cycle Time, Setup, and Job Planning
Turn cycle time into a realistic job duration by including setup time and a measured downtime allowance.
GUIDE / ARTICLEHow to Use Tool Life Data Without Guessing
A practical introduction to the Taylor tool-life equation and why its constants must come from real cutting data.
GUIDE / ARTICLEHow to Estimate Material Removal Rate
Learn the simple MRR relationship between feed rate, width of cut, and depth of cut.
GUIDE / ARTICLEFeed Rate vs Chip Load: The CNC Milling Relationship
See how spindle speed, flute count, and chip load combine to produce a milling feed rate.
GUIDE / ARTICLEHow to Calculate CNC Spindle Speed From SFM
A practical explanation of the spindle-speed formula and the inputs that matter before setting CNC RPM.